This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

keil and assenmbly command

Hi, All:

I have a piece of old assembly code using a specific command SFE which is used to obtain code end address.

RSEG CODE
MOV	DPTR, #SFE CODE

Keil uvision2 said SEGMENT SYMBOL EXPECT in line 1 and SYNTAX ERROR in line 2.

Does anyone has ideas about these codes? Is CODE a specific keyword in Keil?

Thanks!

Parents

0 Jay Daniel over 20 years ago in reply to erik malund

Erik,

And it appears that Maggie and Hans' thread has forced me to eat humble pie. In this case, the abbreviation unequivocally caused confusion. I will henceforth lay down my torch as far as protecting SMS user from retaliation. :)
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Jay Daniel over 20 years ago in reply to erik malund

Erik,

And it appears that Maggie and Hans' thread has forced me to eat humble pie. In this case, the abbreviation unequivocally caused confusion. I will henceforth lay down my torch as far as protecting SMS user from retaliation. :)
Cancel
Vote up 0 Vote down

Cancel

Children

No data