This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IF statement in assembly

I'm wondering, Does assembler support if staments? (like a C program) Tried something very simple:

org 0h
sjmp BEGIN

org 50h
BEGIN:
	IF R0 == #45
		MOV A, #54
		CPL A
	ELSE
		MOV A, #45
		CPL A
	ENDIF
END

After building and enter debug mode I found this code seems to be a #ifdef like statement instead of a C like if-then-else statement. Did I do something wrong or the assembler does no support if statement?

Parents

0 Sergio brasil over 20 years ago in reply to Andy Neil

heheheh Thank God he does not look the code...he would complaint a lot!!!
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Sergio brasil over 20 years ago in reply to Andy Neil

heheheh Thank God he does not look the code...he would complaint a lot!!!
Cancel
Vote up 0 Vote down

Cancel

Children

0 erik malund over 20 years ago in reply to Sergio brasil

heheheh Thank God he does not look the code...he would complaint a lot!!!

In doing so, he will do you a favor. I GUESS you are going to school in order to eventually get a job and, in that case, it is not "complain a lot" but "go to the unemployment line".

Erik
Cancel
Vote up 0 Vote down

Cancel