Hello, I'm using MCB900 Version 4.0 board as ISP programmer. I was able to program P89LPC935 on board chip using Flash Magic Version 2.07. But then I remove P89LPC935 from the board and use 5 Pin connection (Vdd,Vss,Txd,Rxd,RST) to program P89LPC921 using Flash Magic, Flash Magic was not able to communicate with device. Does anybody know how to solve this? ojas
Hi, I'm able to program P89LPC921. Thanks for your help. Ojas
Hello Ojas, I am facing same problem. I have made 5way extensiion cable which connects V3.3,RST,TX,RX & GND, from MCB900 to target PCB where LPC922 is soldered (TSSOP). Can you tell me what you did to solve the problem? It will be nice of you if you can mail me directly also on vital98@eth.net.