• State Not Answered
  • Locked Locked
  • Replies 0 replies
  • Subscribers 20 subscribers
  • Views 458 views
  • Users 0 members are here
Options
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Simulator Timing problem with STR71x

Eugen Mailaender

Hallo,

i'am using uVision3. The selected Target CPU is STR710FZ2T6. In Simulator Mode i can configure the PLL1CR only for multiplying Faktors (MX) of 20,12,16, 28. Reading the Datasheet from ST the Multiplication factor is 24 instead of 28.

What is the correct value?

Thanks,

Eugen

0