hi all, i would like to know whether it is possible to change the baudrate of the serial port to different rates, i have a program which have to communicate with different devices with different baudrates. I try to change the BRGR0 and BRGR1 values but when that part of the code is executed in the simulator, the values do not change to another baudrate different from the default value(115200). Is the code executed not working on simulation or do i have to reset a Register to trigger that UART must be restarted. Any help is appreciated. Many thanks, khaled Sarsam
dear Neil, Thank you for the reply, For example., When i select device one,. the baudrate must be 115200 and the simulation executes it perfectly, i can see the values loaded into BRGR's which have to be 0x00 and 0x30. After that i select my second device(just enabling port P1.3) to trigger the processor that other device has to be selected and the baudrate should be changed to 19200. The program points that it executes the commando's to reload the values of BRGR's with 0x01 and 0x70 for 19200. After that is been done, the serial perpherial show's still 115200 instead of 19200 so it is a bit strange, the registers are loaded with good values but then the Baud does not change on the simulation so that's why i cant see any change in the simulation if i reload the values of BRGR's with different values. so i certainly choose the right values for the BRGR's.