Hi all . In one way ,all the messages is following a standard format ,like:"SOH,MSG ID, CMPL ID,MSG DATA LENGTH, MSG DATA ,CHECKSUM",so this format can be embed in UART_ISR to receive the message wanted.But,if have some different kinds of message which following different formats ,or baudrate is too high to process in the UART_ISR,how can the firmware process these message?Where have any referenced source code ? Thanks for help.
Your code is illegible because it's lost all its latout/formatting. This is because you didn't follow the instruction about posting code. Please follow the instructions on how to post code - it's right there immediately above the box where you type your message! http://www.keil.com/forum/tips.asp