This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Bank For Constant

Hi all

I ve created a bank for constant using

?B_CB           EQU  3

in the file L51IBANK.A51

and also put some modules to the same bank and I decide now to changing bank to these modules, and when I do this I receive a lot of IMPROPER FIXE-UP error and I see that there is enough place for these modules at the target bank.

Any idea

Parents

0 Mustafa Kara over 20 years ago in reply to Jon Ward

I've just started to use LX51 extended linker, when I try to creat an application consisting 4 banks with bankarea 0x0200-0x0400
altough "COMMON AREA" bigger than 0x0200H byte My project built succesfully.

How can this be possible?

Reply

0 Mustafa Kara over 20 years ago in reply to Jon Ward

I've just started to use LX51 extended linker, when I try to creat an application consisting 4 banks with bankarea 0x0200-0x0400
altough "COMMON AREA" bigger than 0x0200H byte My project built succesfully.

How can this be possible?

Children

No data