This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

how do i configure my memory?

hello,

how do i configure my memory for the kitCONT-167 board?

u10 and u11 is populated by 64k of ram. do i need to do anything special in order to access it?

what is the BUSCON settings? how about the S3 settings? (if u10 and u11 is populated then CS1 needs to be selected right? which means that s3 switch 2 is off and s3 switch 3 is on... or can i leave both off?)

thanks,
fred

0