Hi, everyone! I am developing a fruit-sorter, and this device was controlled by PC. Now, I want to design a microprocessor system to execute it. About hardware, I don't want to change too much, so there is a problem I need to work out--- How to implement communication between AD convertor and my microprocessor system ? Need what kind of technologies? What about hardware? software?
"I need use a microprocessor system to replace PC." Why? "Thus, this device's price will become low." Don't forget the cost of all the time & effors needed to design the microprocessor system, port the software, test, etc, etc. IS it really cheaper than a single-board PC, or PC module - which would probably run your existing software, and support the same interface to the ADC.