This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

serial interface on MCB167-NET while running debugger

Hi,

i'm using MCB167-Net board with uvision2. I want to connect a serial printer to this board. But since this board uses the same port to download monitor 166 and my code in the RAM, how should I test my printer?

Regards

Sonali

Parents

0 Keil Support Intl. over 23 years ago in reply to sonali kale

The configuration of the Monitor-166 is described in detail in the file

Keil\C166\Monitor\Readme.TXT.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Keil Support Intl. over 23 years ago in reply to sonali kale

The configuration of the Monitor-166 is described in detail in the file

Keil\C166\Monitor\Readme.TXT.
Cancel
Vote up 0 Vote down

Cancel

Children

No data