• State Not Answered
  • Locked Locked
  • Replies 5 replies
  • Subscribers 21 subscribers
  • Views 1030 views
  • Users 0 members are here
2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

serial interface on MCB167-NET while running debugger

sonali kale

Hi,

i'm using MCB167-Net board with uvision2. I want to connect a serial printer to this board. But since this board uses the same port to download monitor 166 and my code in the RAM, how should I test my printer?

Regards

Sonali

Parents
  • 0 in reply to sonali kale

    See Keil\C166\Monitor\Readme.txt as suggested in Keil Support response.

    1] Where will I find a step by step documentation for implementation of simulated serial mode?
    In readme.txt. As for burining it into your target flash, you will have to use the flash tools provided with the board. These will require the use of the bootstrap mode and the internal UART. You can also try 'memtool.exe' which is downloadable from the Infineon website.

    2] Where will I find the hex code for monitor to be burned in flash?
    You create it in a build - see readme.txt.

    3] How do I simulate a serial interface?
    You select it by setting a define - see readme.txt.

    4] What data should I send to this serial interface and in what sequence?
    The actual format of the command/data/status transmissions are proprietary to Keil in UV2. The monitor source is not distributed, just the configuration portion.

    Best luck

Reply
  • 0 in reply to sonali kale

    See Keil\C166\Monitor\Readme.txt as suggested in Keil Support response.

    1] Where will I find a step by step documentation for implementation of simulated serial mode?
    In readme.txt. As for burining it into your target flash, you will have to use the flash tools provided with the board. These will require the use of the bootstrap mode and the internal UART. You can also try 'memtool.exe' which is downloadable from the Infineon website.

    2] Where will I find the hex code for monitor to be burned in flash?
    You create it in a build - see readme.txt.

    3] How do I simulate a serial interface?
    You select it by setting a define - see readme.txt.

    4] What data should I send to this serial interface and in what sequence?
    The actual format of the command/data/status transmissions are proprietary to Keil in UV2. The monitor source is not distributed, just the configuration portion.

    Best luck

Children