We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi is there anyway of knowing if the LPC is receiving pulses on its INT0 pin. I have it already set up like this: IT0 = 1; //Pulses are edge detected EX0 = 1; //interrupt enable bit EA =1; It works fine, but is there anyway to find out if the pulses have stopped coming into this pin? The time the pulses will be present at this pin is unknown. This message is also posted at http://www.8052.com/forum/post.phtml
Drew Davis Thank you very much for you help. I will go over your posted message.