This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NON BANKED source above 0x8000 not shown in debugee with CYGNAL 8051F124

Hi,
I've the same problem as Dan Kneipp with Cygnal device - source above address 0x8000 is not mapped when running debugger (only ASM is shown).
The difference is the code IS NOT BANKED and has constants in range 0x0000-0x8400 and code above till 0xA000.

C51 v7.03
A51 v7.03
BL51 v5.02
CYGNAL uVision driver v.1.33