I am using Atmel AT89C5131 64pins. From the Atmel website, I found these programs - Keil uVision and Flip 2.2.4. I would like to confirm whether it is true that I can use the Keil uVision 2 to generate the HEX file and then use the FLIP 2.2.4 to program the HEX file into the microcontroller or I can use the Keil uVision 2 to program into the microcontroller? I intend to use USB connection to program into the microcontroller. Is it true that I can program the HEX into the microcontroller directly through USB or I need special programmer? In the Keil uVision 2 program under AT89C5131 data base, I found this statement:- FLASH="batchisp" (-device $D -hardware RS232 -port COM1 -baudrate 19200 -operation MEMORY FLASH LOADBUFFER %H PROGRAM) I don't know what this statement means. Does it mean that I need to use BatchISP to program or I can use FLIP2.2.4. As far as I am concern, BatchISP uses serial com while I intend to use USB connection. Thank you very much for your response. I know this is a very long question. I appreciate all comments and thank you in advance for your help. Thanks.
I will not use Atmel due to some experiences, but seem to recall somewhere that the chips are available with differnt suffixes meaning either ISP via USB or ISP via UART. You need the USB version to achieve what you want. Erik Moderator: Please immediately remove posts not in english or the next will be in kroatian, greek or farsi and the whole idea will go bad thanks Erik