I'm evaluating the Demo version of the ARM7 tools from Keil and notice a lot of unusual quirkiness when dealing with the Flash erase procedure called out in Philips' IAP section. Many times I've had to power down the eval MCB2100 board, constantly re-enter Debug mode, do the hokey-pokey, etc. to re-establish the code and get it to run. On one occasion, I had put into the Memory Window address 0xFFFFF030 (or any other address from the Vectored Interrupt Controller (VIC)) and my target just froze up. Anyone else experiencing strange stuff with this eval board and ARM7 tools? Thanks.
Do not worry about the BOOTLOADER VERSION. It is not important.
Hi, I have other information from Philips. The problems of IAP and ISP erase depends on the boatloader version. Andreas
Per the LPC2000 Flash Utility V2.0.3, the Part ID:33685267 Boot Loader ID:1.5 The Demo PCB has a LPC2129. Yesterday I zipped up and emailed my project to support@keil.com. Did you get it? Best regards, -Jim