Hi, there, I want to use uv2 to debug a system consisting of a set of C codes and one hex file. The C codes will read the data from this hex file. In uv2, I have created a project for this set of C codes, I can debug/trace the their execution. The question is how to include the Hex file into this project? Plausible solution 1, I added the Hex file into the project along with the C codes, and specify the Hex file's type as "Text file". The C codes could *not* read the data from the Hex file correctly. Plausible solution 2, in the "Options for Task" popup utility, there is a Linker panel. However, I didn't figure out where to put the Hex file. Any suggestion? For details of my task, please refer to the following discussion thread. http://www.keil.com/forum/docs/thread3564.asp Kan
Thanks. I will try the approach. For "a byte(int) array", thanks for the reminder. In my specific case, the Java VM will cast the byte into int, hence, it is not an issue for me. However, I agree with you, for general purpose, it is a very important issue to pay attention to. Many thanks again, Kan