• State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 19 subscribers
  • Views 907 views
  • Users 0 members are here
Options
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

c167 stepper motor control

John Lee

Hi
I am trying to interface a Stepper motor with a c167 microcontroller. I am using the motor to tilt and pan a camera. the motor can only move a maximum of 10 degrees per step.

I would be grateful for any thoughts or suggestions of how to go about this.

thanks

0