This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IAP access with Phillips P89C668

Vuppuladhadium Venkataramana over 22 years ago

I'm using a Philips P89C668 that provides
In-system Application Programming (IAP) with have an entry address at 0xFFF0. Is there a clever way to access the IAP functions directly from C without the need to write assembler interface routines?

Thanks, Venkat

Parents

0 Vuppuladhadium Venkataramana over 22 years ago

Not sure if 2045.htm applies to P89C668.
Can someone confirm this ???

http://www.keil.com/support/docs/2045.htm

Thanks, Venkat
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Vuppuladhadium Venkataramana over 22 years ago

Not sure if 2045.htm applies to P89C668.
Can someone confirm this ???

http://www.keil.com/support/docs/2045.htm

Thanks, Venkat
Cancel
Vote up 0 Vote down

Cancel

Children

No data