We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi, I have just started using the Keil Development tools. I created a timer example that should toggle a port pin, approx every half second. With a generic 8051 it works. When I convert the code to the Cygnal C8051F320, power on resets are generated before my code gets to the wait for timer interrupts loop. The code runs ok on an actual Chip. I assume that this is not a bug, but something I am doing wrong. Could this be caused by not using the Startup.A51 file?
Whgy, oh Why are you guys mucking around with a simulator when Cygnal gives you an ICE 'for free'? Erik
Hi, I doesn't work so I am not using it. But I wanted to debug my smb bus interface with the simulator. The other board has an FPGA on it and I am using the smb bus to communicate with it and other devices on that board. Since I am doing the smb bus controller on the FPGA, I would like to know that my Cygnal code is working. I ended up connecting an EEPROM to the bus for debug and then I will debug the FPGA with some confidence that the Firmware is correct. Brad
Which tool version are you using? The F320 simulation is pretty new and was added recently.
Hi, I purchased the simulator upgrad to the C compiler about two weeks ago. The CA51 to DK51 upgrade is Version 7.06 (on the envelop). uVision2 V2.38 target DLL: CygC8051F.dll V1.36