This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XC161CJ and I2C

Hi Everybody,

I'm experimenting with Infineon's XC161CJ-controller on an Infineon SK-XC16x starter kit. Most of my routines work now, except the I2C-routines. Sending of data works OK, but the errors occur when I want to receive data.

Has anybody on this forum written I2C-routines for this controller? And if so, are you willing to share them?

Thanks in advance. :)

Kind Regards,
Dennis Ebben

Parents
  • Dear Stefan and Friends,

    I am also working on an I2C – EEPROM(FM24C256) application for XC167, so far I have used Dave generated code but I got into trouble. Writing works fine but reading…not.
    Stefan, is it possible for me to share your I2C code? My e-mail address is ai(at)home.se

    With best regards,

    Atsushi Ishii

Reply
  • Dear Stefan and Friends,

    I am also working on an I2C – EEPROM(FM24C256) application for XC167, so far I have used Dave generated code but I got into trouble. Writing works fine but reading…not.
    Stefan, is it possible for me to share your I2C code? My e-mail address is ai(at)home.se

    With best regards,

    Atsushi Ishii

Children
No data