This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XC161CJ and I2C

Hi Everybody,

I'm experimenting with Infineon's XC161CJ-controller on an Infineon SK-XC16x starter kit. Most of my routines work now, except the I2C-routines. Sending of data works OK, but the errors occur when I want to receive data.

Has anybody on this forum written I2C-routines for this controller? And if so, are you willing to share them?

Thanks in advance. :)

Kind Regards,
Dennis Ebben

Parents
  • Dear Dennis & Stefan,

    sorry about the response delay,
    but I had to focus on some other matters.

    I have given the code a short glimps, and I think it will be helpful for me when I continue working with the IIC-Code.

    I got the routine I was working with at the time up and running before I recived your email Stefan, but I am grateful for your assistance,maybe I'll come back to you later regarding this...

    Best regards,

    Rolf

Reply
  • Dear Dennis & Stefan,

    sorry about the response delay,
    but I had to focus on some other matters.

    I have given the code a short glimps, and I think it will be helpful for me when I continue working with the IIC-Code.

    I got the routine I was working with at the time up and running before I recived your email Stefan, but I am grateful for your assistance,maybe I'll come back to you later regarding this...

    Best regards,

    Rolf

Children
No data