This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Different behaviour in debugging and stand-alone

Hello!
I've got the problem that the same code works different in debugging mode and in "normal" stand-alone mode.
In debug mode - with or without any breakpoints - all works nice, but when I disconnect and run the program stand alone it doesn't work.
I use the F020 with µVision2 V2.37 and C51 V7.05.
Thanks for any hint!

Astrid

Parents

0 HansBernhard Broeker over 22 years ago in reply to Astrid Wonner
I don't know that particular chip. But this:

RSTSRC == 0x08

is not the way you should be testing whether bit three in this register is set. This rather tests whether bit 3 is set and all others cleared. You want

(RSTSRC & 0x08) == 0x08

or something similar, instead.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 HansBernhard Broeker over 22 years ago in reply to Astrid Wonner
I don't know that particular chip. But this:

RSTSRC == 0x08

is not the way you should be testing whether bit three in this register is set. This rather tests whether bit 3 is set and all others cleared. You want

(RSTSRC & 0x08) == 0x08

or something similar, instead.
Cancel
Vote up 0 Vote down

Cancel

Children

0 Astrid Wonner over 22 years ago in reply to HansBernhard Broeker

Hello!

The while(1)-loop is within the else-part.
The problem was the test indeed! Thanks very much!!
Cancel
Vote up 0 Vote down

Cancel