HI, I am trying to communicate with a board that has the XC161 step AA and one 8bit external RAM at CS0 for debugging. Until now the success ( :) ) is : in EA and bootstrap, sending a 0x0 the uP answers with A5 which I believe is fine! I have KEIL ULINK but I only get "device can not enter bypass mode. connection to target missing or incorrect." like if it is not connected. I have been trying to understand th OCDS and it seems it must have a monitor!? Does ULINK has all this? That is if connect ULINK and call it on uVision I must get something even if no sw is loaded? I make some measurements and I see TRST changing but nothing on TDO! Also I can not load any monitor on the board. So in conclusion I can not load anything on it. Does anyone has evere worked with XC161 and has any monitor or ULINK experience? If so can anyone explain to me if there is some tricks with it? thanks®ards2all, joao
Sorry, still not able to duplicate this issue. Did you define the functions as 'static'? Can you send a small example project that shows this to: support.intl@keil.com
Just sent it. You can contact me on my email if you wish.
I have not got your email so far. Are you sure that you have send it to: support.intl@keil.com?
Yes and no errors on delivering! I have forward it again and I set up "the request delivery receipt." After a short interval: " Your message has been relayed to the following recipient(s): support.intl@keil.com Message relayed The message was successfully delivered to 1 recipient(s) at domain keil.com. "