Currently, I am evaluating the Keil µVersion2 IDE this comes with the Infineon Starter Kit SK-167CR(Phytec KitCON-167). I have done a few basic things using the debugger for loading the programms into the board. This is working fine, since the debugger knows this SK. The next step was for me to bring such a small programm working in the flash-rom. I discovered very quickly this i had to generate a 'start167.a66' file. For this purpose i choosed Dave, builded a project and took the start.asm into (my)/a Keil project, and the Leds flashed like predicted on port 2 but the CAN-bus remains silent. If i am downloading the same programm with the debugger into the SK, the CAN-Bus is trying to send a message continuously too, since i have only conneted a scope on pin 2 and GND of the CAN Sub-D. So far(endless hours) i failed to find the reason why the CAN is not transmitting anything, if the programm starts from flash. I still belive it could may be an error in my start.asm file. So i am looking for a Reference "start.asm" file for my Starter Kit. (Jumper Settings are in the delivery mode) Where can I find such a file ? I am looking for any hints to solve this problem. Thomas
I meet the same question,but don't know how to solve it. If Some body had solved this problem,please email me ! email: shzhj@sohu.com thanks. shen