hi! sorry for posting here cause i dont know if i'm in the right forum but my english is very bad and i dont know about the products or have any sense of mircocontroller etc..a girlfriend wanted that i asked here this question in this forum cause she uses the uVision 1 tool for her job and everytime she trys to wirte the programm,uvision write it to the offset 4000which can't be writen with her at 89S8252.she wants to write the code on the position 0.who can she do that? can anybody help me please? need it fast cause she has to do this for her job education.. thanks a lot for everything nico maas
I think this is one of the limitations of the evaluation (free) version. Stefan
no its the full version i think.were can i do this seeting?
Are you sure? This is certainly one of the restrictions imposed by the free evaluation versions. If she is just learning, wouldn't it be much better to learn on the current version, rather than this ancient version? Can't she post herself - that'd make things much easier?!!
her english is more bad then my. so i do this.version 2 can't used cause there are some problems.hm well only say how to change ^^#.and in the "test" version of version 2 it cant be programmed from offset 0 right? ^^# hm well please give me only the seeting for the offset change,then i'm glad ^^