• State Not Answered
  • Locked Locked
  • Replies 5 replies
  • Subscribers 22 subscribers
  • Views 1099 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

LCD- Display to 8051

Thomas Hinst

Hello, i have a problem. I want to connect a LCD-Grafic-Display with a Hitachi HD61202 Controller to a 80c592. Is it possible? Know someone how to do this? Could someone give me a tip?

Thanks

Thomas

Parents
  • 0

    Hi,
    I attached a 240x128 graphics LCD (Optrex) which uses a Toshiba controller. It is atttached to the address/data bus and requires 5 wait states (ST10F167 @ 20Mhz)during access. Because of it's pinout I had to use a polled ready/busy protocol but was quite successful. The best bet is to get the controller app notes from Hitachi and then pull a search for 'LCD' and HD61202 on the internet. I found enough tutorials and user hints to get the whole thing running in just a couple of hours.

    Best Regards
    Scott

Reply
  • 0

    Hi,
    I attached a 240x128 graphics LCD (Optrex) which uses a Toshiba controller. It is atttached to the address/data bus and requires 5 wait states (ST10F167 @ 20Mhz)during access. Because of it's pinout I had to use a polled ready/busy protocol but was quite successful. The best bet is to get the controller app notes from Hitachi and then pull a search for 'LCD' and HD61202 on the internet. I found enough tutorials and user hints to get the whole thing running in just a couple of hours.

    Best Regards
    Scott

Children
No data