This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can I set breakpoints in XC161CJ flash using just the serial monitor?

Does the Keil 166 toolset support debugging programs running in the flash of the XC161CJ using just the serial port? That is, will the monitor allow me to set breakpoints using the on chip debug facility without a special jtag wiggler?

Parents

0 Doug Moore over 23 years ago in reply to Keil Support Intl.

We may be switching from a C167 to a XC161CJ. One of the primary reasons for the change is OCDS. Assuming we make the change, and I should know within the month, how do I get a beta ulink or parallel device? They aren't listed on the site as products for purchase.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Doug Moore over 23 years ago in reply to Keil Support Intl.

We may be switching from a C167 to a XC161CJ. One of the primary reasons for the change is OCDS. Assuming we make the change, and I should know within the month, how do I get a beta ulink or parallel device? They aren't listed on the site as products for purchase.
Cancel
Vote up 0 Vote down

Cancel

Children

0 Keil Support Intl. over 23 years ago in reply to Doug Moore

In which country are you located?
Cancel
Vote up 0 Vote down

Cancel
0 Doug Moore over 23 years ago in reply to Keil Support Intl.

I'm in USA, Austin, TX.
Cancel
Vote up 0 Vote down

Cancel