This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

uV2 Command Line switches

Using the uV2 command line switches to build several projects, it constantly opens the full UI of uV2.

Can this be avoided and simply output compilation/linking text to the console?

Also, are there any documention on the ERRORLEVEL values returned from an invocation of uV2, to allow exiting of a batch of builds when an error occurs?

Finally, can the 'run user program' after build be prevented when an error occurs during the build?

TIA

Parents
  • "can the 'run user program' after build be prevented when an error occurs during the build?"

    What version do you have?

    I asked Keil support about this once, and they said, "No."
    However, now that I have uVision v2.23 I note that it doesn't run the 'user program' when an error occurs during the build!

    (this is doing it in the IDE; dunno if it might be different from the command line)

Reply
  • "can the 'run user program' after build be prevented when an error occurs during the build?"

    What version do you have?

    I asked Keil support about this once, and they said, "No."
    However, now that I have uVision v2.23 I note that it doesn't run the 'user program' when an error occurs during the build!

    (this is doing it in the IDE; dunno if it might be different from the command line)

Children
No data