We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
I had wrote on this subject last year and put the project down until now. I am having a problem when an external device sets its address lines to outputs while connected to the EZ-USB AN2125 chip at Port D. I an2125 goes into an unknown state. I am using the fast read and fast write on the an2125 and the fast write works just fine. When I attempt to do a fast read the the external device swithches to an output is when the an2125 loses control. Any help would be appreciated.
Can you send me information on how to set up the options on Target of the monitor for debugging purposes? Thank you for your help!