• State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 22 subscribers
  • Views 753 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Run Monitor-51 out of Com 0 on 8051

Tom Roe

I would like to run the Monitor-51 out of com 0 instead of com1 on the 8051 board I am using. Do I need to get a copy of Monitor-51 that allows this?

I am using a cypress ezusb dev board and need the sio-1 pins for the GPIF interface

Thanks
Tom

Parents
  • 0

    Have the same requirement. Have found that alternative monitors exist.

    Look in directory C:\Cypress\USB\Target\Monitor\Ezusb - there are several options.

    To install monitor from EZ-USB Control Panel select Options|Properties|Paths and set path for monitor to C:\Cypress\USB\Target\Monitor\Ezusb\mon-ext-sio0.hex

    It seems to work. Good luck!

Reply
  • 0

    Have the same requirement. Have found that alternative monitors exist.

    Look in directory C:\Cypress\USB\Target\Monitor\Ezusb - there are several options.

    To install monitor from EZ-USB Control Panel select Options|Properties|Paths and set path for monitor to C:\Cypress\USB\Target\Monitor\Ezusb\mon-ext-sio0.hex

    It seems to work. Good luck!

Children
No data