hallo; how can i see a result via hyper terminal (ex: com1) for debug session?? i can see the result via serial window,but i want to see the result via com1.I set the parameters for the PC serial ports using the MODE and ASSIGN command: mode com1 9600,0,8,1 assign com1 <sin> sout when i done the setting ,i still can't see the result from terminal. Anyone could help me? ps:i am not good in english.
"3.open a hyper terminal (i had done the config for com2)" You need to adjust the settings from within hypoterminal Don't forget: although hypoterminal shows the changes immediately on its Status Line, they don't actually take effect until after you disconnect & then reconnect! Just one of the very many annoying and misleading features of hypoterminal to which I alluded earlier :-( Have you also set hypoterminal correctly to recognise your ANSI sequences? Have you tried linking 2 hypoterminal sessions - to check that your cable link is OK?
Now I can see the result on the terminal. I re-check the cable and found the cable was broken. thx a lot for your help.....!!