This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How do you do Trace Recording with Mon51?

Has anyone figured out how to enable and view trace recording when using the UV2 debugger with Mon51?

These commands are disabled when I build my project for debug with Mon51. However, they do work if I use the simulator (including itrace=1 and itrace=0 at the debugger command line).

I'm running uVision2 v2.06 with C51/A51 v6.02.

Thanks,

Mark

Parents
  • Given what you said regarding the degradation of performance via the serial interface when trace recording is turned on, I'd agree that the feature wouldn't be very useful in most cases. However, I'd still like to know how to enable the feature in case there's a situation where I can use it. How did you enable it?

Reply
  • Given what you said regarding the degradation of performance via the serial interface when trace recording is turned on, I'd agree that the feature wouldn't be very useful in most cases. However, I'd still like to know how to enable the feature in case there's a situation where I can use it. How did you enable it?

Children
No data