Having problems when debugging. Stepping halts when a line of code with port 3 is encountered (ie P3 = 0x07). I'm getting timeout error messages. Also, P1.7 stays on constantly, is this due to A17 being configured for this port bit? Are both problems due to board configuration? Any help with downloading my program into an external eprom is also appreciated. The microcontroller is a 80C251SB. I'm new at this and totally in the dark.
Can pins from port 3 be used as general I/O pins rather than RXD, TXD, RD, WR etc.? /RD and /WR can be used if you don't have external RAM/ROM. However, if that's the case, P0 and P2 can be used as well. Jon