Hello NG, I wanted to configure Monitor. So I followed the steps described in "/Keil/C166/Monitor/Readme.txt". I decided to use the UART ASC0 mode and put CODE_START in "Config.inc" to 000200H (rom, after the vectors). The problem is that there are no vectors (i.e. no jump to start at 0, no jump to NMI at 8, ...) What I made wrong? Thanks - Peter
Hello NG,<br> <br> I wanted to configure Monitor. So I followed the steps described in "/Keil/C166/Monitor/Readme.txt". I decided to use the UART ASC0 mode and put CODE_START in "Config.inc" to 000200H (rom, after the vectors). The problem is that there are no vectors (i.e. no jump to start at 0, no jump to NMI at 8, ...)<br> What I made wrong?<br> <br> Thanks - Peter<br>
Thanks for you helpful intention. But on your answer I recognize only my question. Please try again to type you answer. Bye - Peter