Hallo, I have uVision2 version 2.06. But I don't know how to create a "flashable" .hex file for my C167CR-LM. In the menu "Project" --> "Options for Target" --> "Output", do I have to set a "Start" and "End" address for creating a hex file? And what should I write in the field "FLASH Fill Byte" and "Offset"? For flashing my Infineon uC, I use Flashtool 16W from Phytec. Thanks a lot, Daniel
THe Fill Byte section depends of your flash specification (erase value is 00 or 0xFF). But into the empty section you can also insert a special value to know if you have read a bad section in the memory best regards yael