This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Generate "flashable" Intel HEX file

Hallo,

I have uVision2 version 2.06. But I don't know how to create a "flashable" .hex file for my C167CR-LM. In the menu "Project" --> "Options for Target" --> "Output", do I have to set a "Start" and "End" address for creating a hex file? And what should I write in the field "FLASH Fill Byte" and "Offset"? For flashing my Infineon uC, I use Flashtool 16W from Phytec.

Thanks a lot,

Daniel

Parents
  • Hello Daniel,

    We are encountering the same problem as you did. Have you actually figured this out?
    The Hex files that we are producing with Keil do not execute when downloaded into flash of Phytec kitCON-167 with Infineon micro.

    Thanks,
    Saeed
    snejatali@azuredynamics.com

Reply
  • Hello Daniel,

    We are encountering the same problem as you did. Have you actually figured this out?
    The Hex files that we are producing with Keil do not execute when downloaded into flash of Phytec kitCON-167 with Infineon micro.

    Thanks,
    Saeed
    snejatali@azuredynamics.com

Children
No data