We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
I just installed the new C51 patch. I'm not sure if that has anything to do with it, but now when I build my project I get all these ?C?COPYAMD errors. Any help would be appreciated.
What happens when you compile and link the following program? I get no errors. I've uninstalled the new patch and reinstalled the previous version, so I can't test right now. If it helps, I'm using the Dallas 87C520 chip. Also I received this from Keil support: Dear Ted, I have confirmed your problem and I will forward it to our engineers. I will email a fix, as soon as one becomes available. I apologize for the inconvience. Best regards, Darnell Pouncil
Here's what we figured out. For some reason, the SETUP program does not install the correct .LIB files in some cases. Typically, when you install the software 2 times. To rectify the problem, uninstall the software and re-install it from the V6.10a update. Then, you will have the correct full-blown libraries. Jon
Here's what we figured out. For some reason, the SETUP program does not install the correct .LIB files in some cases. Typically, when you install the software 2 times. To rectify the problem, uninstall the software and re-install it from the V6.10a update. Then, you will have the correct full-blown libraries. Jon Will this also fix the Serial Port Simulation window problem? http://www.keil.com/forum/msgpage.asp?MsgID=867
I have uninstalled, deleted all directories and registry entries and still no luck. I have copied over the libs from V6.02 and all seems ok so far, but not the best solution for an update.
I tried to answer what I found on a later thread http://www.keil.com/forum/msgpage.asp?MsgID=1023 -Eric esoutham@inari.com