• State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 22 subscribers
  • Views 1983 views
  • Users 0 members are here
Options
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No target get connected error getting on loading code in STM32L1CB microcontroller chip

Toolchain missing

Hi,

Thanks to member for the solution providing.

I have generate led blinking project for MDK ARM Keil uvision5.25 using STM32CUbeX IDE.
Project is compiled successfully with 0 error.
Getting Error " As not target connected" when i try to load the firmware as per attached images.
Connecting STM32L151CB microcontroller to ST-LINK/V2 Programmer with given 5 pin ->1) VCC 2) GND 3) SWDCLK 4) NRST 5) TMS/SWDIO

Its kind request to you to provide me the solution to resolve these error as soon as possible.


Thanks and regards,
RRJ

0