• State Accepted Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 5 replies
  • Subscribers 20 subscribers
  • Views 8501 views
  • Users 0 members are here
2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Is Juno Board suitable for ARM BSP development?

Nitin Chaudhary

We are interested in developing Board Support Package and Bootloader code for SOCs based on ARMv8 Architecture (A57/A53). Can someone please suggest is Juno Board a good option for it?

We are interested in writing the BSP code for Memory Controller, UART,GIC,CCI etc. In a nutshell we want to replace the Bootloader coming with Juno Board deliverable with our own developed Bootloader code except the Boot ROM code. Is it possible to do it on Juno Board?

Parents
  • 0 in reply to Ash Wilding

    Thanks Ash again for the update.

    Suppose, we have a requirement where we want to change the parameters like DDR Timings, refresh settings, active bank etc in the kernel after the boot. So, is it possible to achieve in the Juno board after the SCP firmware has been loaded by the BL?

    Thanks & Regards,

    Nitin

Reply
  • 0 in reply to Ash Wilding

    Thanks Ash again for the update.

    Suppose, we have a requirement where we want to change the parameters like DDR Timings, refresh settings, active bank etc in the kernel after the boot. So, is it possible to achieve in the Juno board after the SCP firmware has been loaded by the BL?

    Thanks & Regards,

    Nitin

Children