Support forums

Arm Development Platforms forum My code is not working if i change the address of flash memory , where the code can be loaded and if change the address back to the base address 0x80000000 then it works. Why?

State Not Answered
Locked Locked
Replies 3 replies
Subscribers 21 subscribers
Views 24442 views
Users 0 members are here

2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

My code is not working if i change the address of flash memory , where the code can be loaded and if change the address back to the base address 0x80000000 then it works. Why?

aarushi over 6 years ago

I am trying to make a custom bootloader, and for that i need to change the flash memory address of the user code (the code which i will upload through the bootloader). So , i made a GPIO Toggle code with no delay, and in the target dialogue box i am changing the IROM1 address to 0x8009000 and also in the linker dialogue i am changing the R/O address to 0x8009000. But after changing the address my code is not working/executing, and i don't know why!