Arm Development Platforms forum How to trigger a Lisa+ model behaviour through a slave port <signal>?

State Accepted Answer
Locked Locked
Replies 2 replies
Subscribers 21 subscribers
Views 17558 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to trigger a Lisa+ model behaviour through a slave port <signal>?

Ramarro over 5 years ago

Hello,

I am developing the model of a block for a virtual platform using Lisa+.

I know how to trigger a behaviour through read and write accesses on the PVBus. However I don't know how to do that for a slave port <signal>.

Can you please explain me how to do that? I haven't been able to find anything in the documentation.

I would really appreciate if you provide me with some simple example code.

Thank you in advance.

Best regards,

R.

Top replies

Rob Kaye over 5 years ago +1 verified

Are you using Fast Models to do this? If so, take a look at the signalogger component. This has examples of how to do this on both slave and master ports. In summary signal_master_port.setValue(sg::Signal...

Parents

0 Ramarro over 5 years ago in reply to Rob Kaye

Hi Rob,

thank you for the explanation. Yes, I'm using Fast Models.

I've been able to implement it now. The idea of having a setValue behaviour for implementing the sensitivity of a slave port was a bit misleading for me, but now I have understood.
Cancel
Up 0 Down

Cancel

Reply

0 Ramarro over 5 years ago in reply to Rob Kaye

Hi Rob,

thank you for the explanation. Yes, I'm using Fast Models.

I've been able to implement it now. The idea of having a setValue behaviour for implementing the sensitivity of a slave port was a bit misleading for me, but now I have understood.
Cancel
Up 0 Down

Cancel

Children

No data