Please note: We are aware of an issue affecting replies on the Arm Community forums, which may not be loading as expected.
We apologize for any inconvenience and appreciate your patience while we investigate and work to resolve the issue.
Thank you for your understanding.
Hi,
I have a strange issue, that on a bootloading project of mine worked if compiled with ARM Compiler 6.12 but did not if compiled with 6.13.1.
The function of the firmware is very simple: when it boots, it checks a (volatile) memory location for new FW, if found, it compute the CRC of its content and compares against the written CRC. If they match, it writes the FW into non-volatile location and sets MSP to where the main FW starts.
The boot loader FW could run, but it somehow altered a piece of memory which was not touched by the image compiled with 6.12, even though I have specifically marked that area as EMPTY in the scatter file, and the pointer used to read that memory is a CONST pointer. I have made sure that the memory wasn't altered by the main FW.
I have read the release notes of 6.13, nothing seems to fit my problem.
I have tried to compare the listing of disassembled files from the two AXF, but was overwhelmed by the number of difference. Is there any quick way by which I can spot the difference?
Thanks in advance.
Hi Seng Tak,
Sorry for slow reply, I have been out of the office for a few days.
From the above, do I understand that you now have things working - do you need any further information from me?
Regards
Ronan