Arm Development Studio forum How do I debug NXP-iMX7 SABRE board using MD-5?

State Accepted Answer
Locked Locked
Replies 4 replies
Subscribers 122 subscribers
Views 8569 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How do I debug NXP-iMX7 SABRE board using MD-5?

Oferkel over 7 years ago

I am trying to connect to NXP iMX7 SABRE board using usb cable as a serial connection.

How should I configure the debugger to connect?

Top replies

Parents

+1 Ronan Synnott over 7 years ago

See also https://community.arm.com/tools/b/blog/posts/getting-started-with-ds-5-and-i-mx7
Cancel
Up +2 Down

Cancel

Reply

+1 Ronan Synnott over 7 years ago

See also https://community.arm.com/tools/b/blog/posts/getting-started-with-ds-5-and-i-mx7
Cancel
Up +2 Down

Cancel

Children

0 Oferkel over 7 years ago in reply to Ronan Synnott

thanks Ronan, your article had been very educating and useful for me!
Cancel
Up 0 Down

Cancel