This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to enter USR mode from SVC mode?

Note: This was originally posted on 1st August 2011 at http://forums.arm.com

I changed CPSR to 0x1D0(which means USR mode )in SVC mode in cortex-a8 platform(freescale imx51), but a perfetch_error occured, the PC hung at 0x0c. Could anybody help me figure this issue out, please?
OR anybody has some code some hwo to enter USR mode from SVC mode?

Best Regards
Jerry

Parents

Christophe Beausoleil over 12 years ago

Note: This was originally posted on 2nd August 2011 at http://forums.arm.com

Hi Jerry,

Hum, it is strange, because Cortex-A8 and R4 seem to share the same architecture !? What is your compiler ? (for me, it works with both RVCT 4.0 and CCS v4)

did you also try
msr cpsr, r1
?

cpsr_c is a sub mask for writing only specific bits... maybe not available for cortex-A8

Regards

Christophe
Cancel
Vote up 0 Vote down

Cancel

Reply

Christophe Beausoleil over 12 years ago

Note: This was originally posted on 2nd August 2011 at http://forums.arm.com

Hi Jerry,

Hum, it is strange, because Cortex-A8 and R4 seem to share the same architecture !? What is your compiler ? (for me, it works with both RVCT 4.0 and CCS v4)

did you also try
msr cpsr, r1
?

cpsr_c is a sub mask for writing only specific bits... maybe not available for cortex-A8

Regards

Christophe
Cancel
Vote up 0 Vote down

Cancel

Children

No data