This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Hard Fault on cortex M3 NXP

Note: This was originally posted on 20th June 2011 at http://forums.arm.com

I've coded a small program to download in a usb memory some data acquired from the LPC1768 Cortex M3.
I use IAR EW to code and J-Link LITE to program/debug the code.

So, when I test my program with debugger connected (either in debug or release mode) it works fine.

When I program the micro and run it without the debugger connected I obtain an Hard Fault exception.

When I check the value of HFSR it return 0x80000000 -> DEBUGEVT = 1 ?

Why? Where is my fault?

Thanks.

Alessandro

Parents

Alessandro Spinetti over 12 years ago

Note: This was originally posted on 20th June 2011 at http://forums.arm.com

Hy Joseph,
I've searched any occurrence of BKPT instruction, but I haven't found it.

It's not simple to debug, I can only put some strings in 16x2 character lcd. I write to the lcd the DFSR value also and the value is 0x2. Maybe the core is in a debug mode?

Thanks.
Cancel
Vote up 0 Vote down

Cancel

Reply

Alessandro Spinetti over 12 years ago

Note: This was originally posted on 20th June 2011 at http://forums.arm.com

Hy Joseph,
I've searched any occurrence of BKPT instruction, but I haven't found it.

It's not simple to debug, I can only put some strings in 16x2 character lcd. I write to the lcd the DFSR value also and the value is 0x2. Maybe the core is in a debug mode?

Thanks.
Cancel
Vote up 0 Vote down

Cancel

Children

No data