This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot set breakpoint in Realview Debugger

Note: This was originally posted on 25th September 2009 at http://forums.arm.com

When I try to set breakpoint in Realview Debugger 4.0, it failed with a popup window, saying "E0039 Line Number not found". Is there anyone have encountered this problem? Thanks.

Attached is the fail picture.

Parents

jameer mulani over 12 years ago

Note: This was originally posted on 3rd October 2009 at http://forums.arm.com

In short, your debug symbols are not matching with Image. rebuild image and make sure that you pointing right source code
Cancel
Vote up 0 Vote down

Cancel

Reply

jameer mulani over 12 years ago

Note: This was originally posted on 3rd October 2009 at http://forums.arm.com

In short, your debug symbols are not matching with Image. rebuild image and make sure that you pointing right source code
Cancel
Vote up 0 Vote down

Cancel

Children

No data