This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

how to profilling with delay time is zero (or) with no wait state

Note: This was originally posted on 21st April 2009 at http://forums.arm.com

Hi Friends,

I want to do profilling of my application with delay time is zero (or) with zero wait state.

Can any one please help me to slove this issue.. please reply soon...

Regards,
Ranjith.
satyaranjith@gmail.com

Ranjith Kumar over 12 years ago

Note: This was originally posted on 12th May 2009 at http://forums.arm.com

Hi Bhushan,

Thanks for reply, After changing MCCFG = 1 in default.ami also i am getting same MHz. No change in profilling data.

Can please tell me the solution to do profilling using ARM Work Bench IDE with wait state as zero.

Best Regards,
Ranjith Kumar K
satyaranjith@gmail.com
Cancel
Vote up 0 Vote down

Cancel
dhadwabh dhadwabh over 12 years ago

Note: This was originally posted on 29th April 2009 at http://forums.arm.com

hi ranjith,
Just set the MCCFG factor in default.ami to 1 .
The relation between MCCFG and wait states is MCCFG = 1 + Wait states.
sorry for late reply since i came across the post today.

Regards,
Bhushan.
Cancel
Vote up 0 Vote down

Cancel