• Locked Locked
  • Replies 3 replies
  • Subscribers 118 subscribers
  • Views 2786 views
  • Users 0 members are here
Options
Related
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Newbie: Help me in getting started!

Annim Banerjee
Note: This was originally posted on 11th December 2012 at http://forums.arm.com

Hello,

This is Annim Banerjee here...
Sorry if i have started a new topic over a wrong place!!!
if yes, then please place this in its correct place...


I am a clean/New to ARM. That means i dont know what all basic requirements are there to get started with ARM!!!

Platform i am having:
  •   i got my development board which has a LPC2138 pre soldered on it.
  • Few GPIO are out for general purpose tasks...
  • Also got its programmer too.
  • I Am having Flash Magic.
What i am not Having: this is where you people can help me....
  • No awareness of what tools are required for start writing code.
  • NO LPC21xx.h file found under GNU ARM pre-build tool chain.
  • What?Where? is all about startup Code *.S ?
  • Is startup code written manually or genrated automatically.
  • What all terms / terminology required to know before all?
  • Is MAIN.C and any startup .S file sufficient for putting a HEX file onto board via programmer?!
  • Any Freeware IDE for doing development for the same...
  • A good tutorial, as setp-by-step, or even DIY sort of!
  • What more... 
Also please , if possible direct me to any such place where i fit to go and get all my answers!!! I hope you all might have got the meaning of my words as described above.
Getting no good results over google / internet with my limited keywords!!

and sorry for asking soo much at once!!

Thank You!!!
Parents Reply Children
No data