Please note: We are aware of an issue affecting replies on the Arm Community forums, which may not be loading as expected.

We apologize for any inconvenience and appreciate your patience while we investigate and work to resolve the issue.

Thank you for your understanding.

  • State Suggested Answer
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 119 subscribers
  • Views 657 views
  • Users 0 members are here
Options
Related

NXP iMX8QM can not trace to DDR by ETR TMC

MoveMOVEMove

Hi ARM:

I am using Arm development studio（Dstream debugger） trace For iMX8QM, using ETR trace to system Mem， but it Cannot work.

But it can debug by Jtag

The config is below:

In Linux Kernel, I have make the 0x880000000 reserved, and cannot visable by linux.



The Chip is broken or any other issue?

Thanks very much.

Parents
  • 0

    In Commands it display some warnings:

    Execution stopped in EL1h mode at breakpoint 4: EL1N:0xFFFF800080D20414
    EL1N:0xFFFF800080D20414 RET
    WARNING(DTS51): Failed to complete manual flush (FOnMan stayed high in FFCR)
    WARNING(DTS50): Failed to stop formatter (FtStopped bit stayed low in FFSR)
    WARNING(DTS286): STS.TMCReady stayed low

Reply
  • 0

    In Commands it display some warnings:

    Execution stopped in EL1h mode at breakpoint 4: EL1N:0xFFFF800080D20414
    EL1N:0xFFFF800080D20414 RET
    WARNING(DTS51): Failed to complete manual flush (FOnMan stayed high in FFCR)
    WARNING(DTS50): Failed to stop formatter (FtStopped bit stayed low in FFSR)
    WARNING(DTS286): STS.TMCReady stayed low

Children
No data