This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Platform Configuration Error in Arm Development Studio program

Hello!!

I had a Platform Configuration Error while using the Arm Development Studio 2023 program with DSTREAM-ST equipment.

My FPGA(XCVU19P) Board is connected to CORESIGHT 20 cable of DSTREAM-ST equipment.

Error content is as follows.

"Scanchain detection failure : Detected number of device =136, maximum allowed = 128. 

 This problem is usually a result of the scanchain not acting correctly when using JTAG scans to count the number of devices."

I want to know the cause and solution of the error.

I thank you in advance for your reply.

Parents Reply Children
No data